KUHN AXIS 20.1, Operator'S Manual

Page: 72 / 216

Standard operating procedure (all models) 8
60
AXIS-GENERAL
Normal spreading in/out of the headland tramlining
When continuing spreading in the field after spreading from the headland tram-
line, please note the following:

Move the border spreading unit TELIMAT out of the spreading area.
Figure 8.19: Normal spreading
[A] End of spreading fan during spreading in the headland tramline
[E] End of spreading fan during spreading on the field
[T] Headland tramline
[X] Working width
The metering slides should be closed or open according to the various distances
travelled to and back from the headland field boundary.
Driving out of the headland tramline

Open the metering when the following condition is fulfilled:
- The end of the spreading fan on the field [E] is approximatively at a distance
of half the working width + 4 to 8 m from the headland field boundary.
The tractor is then located at different distances in the field, depending on the
spreading width of the fertiliser.
Driving into the headland tramline

Close the metering slides as late as possible .
- The end of the spreading fan should ideally come to lie on the field [A] at
a distance of app. 4 to 8 m further than the working width [X] of the head-
land.
- This is not always possible, depending on the casting distance of the ma-
terial and the working width.

Alternatively, you can either drive out of the headland tramline or a second
headland tramline can be laid down.
Follow these directions for an environmentally friendly and economical method of
working.
E
A
X