KUHN AXIS 20.1, Operator'S Manual

Page: 80 / 216

Standard operating procedure (all models) 8
68
AXIS-GENERAL
Figure 8.24: Layout of the catch trays

Set the trays horizontally. Slanted trays may cause measurement errors
(
figure 8.24 ).

Carry out a calibration test (see chapter B.6 for each solid fertiliser broadcast-
er model).

Right and left hand side metering slides should be adjusted and set (see
chapter B.4 for each solid fertiliser broadcaster model).
Run spreading test with the openings set as calculated for the job.

Travelling speed: choose 3 - 4 km/h .

Open metering slide 10 m before the catch trays.

Close metering slides approx. 30 m after the catch trays.
NOTICE
If the quantity in the trays is too low, repeat the run.
Do not change the adjustment of the metering slide.