KUHN AXIS 20.1, Operator'S Manual

Page: 182 / 216

Maintenance and repair C
170
AXIS-GENERAL
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
AXIS 50.1 W
Adjustment:
The metering slide is in the position from work step 2.
3. Unfasten the fixing screws for the scale.
Figure 19: Scale fixing screws
4. Move the entire scale so scale value 85 is exactly at the display pointer.
Tighten the scale again.
Figure 20: Metering slide pointer at position 85
5. Repeat steps 1-4 for the right metering slide.
6. Connect the actuator back to the metering slide
NOTICE
Both metering slides must open by the same amount . Always test both
metering slides.
After scale correction with electronic slide controls, a correction of the slide
testing points in the electronic control system is also necessary.
Please observe the operating instructions for the electronic control system.
1