KUHN AXIS 20.1, Operator'S Manual

Page: 207 / 216

General maintenance and service (all models)
195
9
AXIS
20.1
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
AXIS-MAINTENANCE
Figure 9.10: Gear oil filling and draining points; Left: AXIS 20.1,
AXIS 30.1/40.1, right AXIS 50.1 W
[1] Filling screw
[2] Oil level checking screw
[3] Drain screw
Checking oil level:

Open the oil level check plug.
 The oil level is satisfactory if the oil reaches the lower edge of the hole.
Draining oil:

Tilt the solid fertiliser broadcaster sideways (tilt approx. 200 mm).

Place the collection vessel under the oil drain plug.

Unscrew the drain plug and allow the oil to drain out completely.

Replace the drain plug.
Filling with oil:

Use only transmission oil SAE 140 GL-4.

Open the filler plug and the check plug.

Fill gear oil into the filler hole until the oil level at the check plug reaches the
lower edge of the hole.

Close the filler plug and the check plug.
n
CAUTION
Environmentally correct used oil disposal
Used oil that enters the ground water is a hazard for people and
the environment.
 Dispose of used oil according to the local regulations.

Please note chapter 10.1: Safety, page 197 .
1
2
3