Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 967 / 1502

ip route
Syntax ip route [ vrf vrfName ] { ipAddress ipMask { ipNextHop
[ interfaceType interfaceSpecifier ] | interfaceType interfaceSpecifier } }
[ distance ] [ tag tagVal ] [ permanent ] [ [ verify rtr rtrIndex ]
[ verify bfd-liveness-detection [ minimum-interval minInterval |
[ minimum-receive-interval minRecInterval ]
[ minimum-transmit-interval minTransInterval ] ] ] [ multiplier multValue ] ]
[ last-resort] ]
no ip route [ vrf vrfName ] ipAddress ipMask [ ipNextHop | interfaceType interfaceSpecifier
] [ distance ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Establishes static routes and can also enable Bidirectional Forwarding Detection (BFD)
for the static route. The
no version removes static routes or removes BFD from the static
route.
NOTE: BFD sessions might not be maintained when the multiplier value is 1 and
configured intervals are very short. We recommend that you do not use a multiplier
value of 1 with very short intervals.
Options
•
vrfName —Name of the VRF if the static route is being established within a VRF context;
available only in Global Configuration mode
•
ipAddress —Destination IP address
•
ipMask —IP mask for the destination
•
ipNextHop —IP address of the next hop that can be used to reach the destination
network
•
interfaceType —Interface type; see “Interface Types and Specifiers” on page 5
•
interfaceSpecifier— Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
•
distance —Administrative distance for this route in the range 0–254
•
tagVal —Number in the range 0–4294967295 that identifies the tag for this route
•
permanent—Specifies that the route will not be removed, even if the interface shuts
down
•
verify rtr—Installs the static route in the routing table only if the next hop to the specified
destination address is resolved and if the specified RTR operation is currently reachable
•
rtrIndex —Number of the RTR operation to be verified; there is no default value
923 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands