Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 203 / 1502

atm bulk-config
Syntax atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]*
no atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Configures a range of ATM PVCs for use by a dynamic ATM 1483 subinterface, and assigns
a name to the virtual circuit (VC) range. Each VC range consists of one or more
nonoverlapping VC subranges. A VC subrange is a group of VCs that resides within the
specified VPI and VCI ranges. You can configure multiple VC ranges on an ATM AAL5
interface. The
no version removes the specified VC range (including all subranges in the
range) from the ATM AAL5 interface or the specified subrange from the VC range. The
no version also removes any overriding profile assignments for ATM PVCs within the
deleted VC range or VC subrange.
NOTE: The total number of VCs configured with the atm bulk-config command cannot
exceed the maximum ATM VC capacity of the line module you are using. For details
about the ATM VC capacity of supported line modules, see JunosE Release Notes,
Appendix A, System Maximums.
Options
•
bulkConfigName —Name of the VC range; string of up to 80 characters
•
vpiStart —Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
•
vpiEnd —Ending virtual path identifier (inclusive) of the VC subrange you are configuring
•
vciStart —Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
•
vciEnd —Ending virtual circuit identifier (inclusive) of the VC subrange you are configuring
•
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Mode Interface Configuration
159 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: A Commands