Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1257 / 1502

lifetime
Syntax To set an IKE lifetime:
lifetime seconds
no lifetime
To set an IPSec transport profile lifetime:
lifetime { kilobytes lowKilobytes highKilobytes | seconds txLowSeconds txHighSeconds |
seconds txLowSeconds txHighSeconds kilobytes lowKilobytes highKilobytes }
no lifetime
To set an IPSec tunnel profile lifetime:
lifetime { seconds tunLowSeconds tunHighSeconds | kilobytes lowKilobytes highKilobytes
| seconds tunLowSeconds tunHighSeconds kilobytes lowKilobytes highKilobytes }
no lifetime
Release Information Command introduced before JunosE Release 7.1.0.
IPSec Tunnel Profile Configuration mode added in JunosE Release 7.3.0.
Description From IKE Policy Configuration mode, associates a lifetime with IKE SAs established with
this IKE policy. The
no version restores the lifetime to its default, 28800 seconds (8
hours).
From IPSec Transport Profile Configuration mode, sets a lifetime range for the IPSec
connection in volume of traffic and/or in seconds. If the client PC offers a lifetime within
this range, the router accepts the offer. The
no version returns the lifetime to the default,
100000–4294967295 KB and 900–86400 seconds (1–24 hours).
From IPSec Tunnel Profile Configuration mode, specifies the IPSec lifetime range used
on IPSec security association negotiations. The
no version returns the lifetime to its
default, 28800 seconds (8 hours) and no traffic volume limit.
Options
•
seconds —Number of seconds an SA lives before expiring; in the range 900–86400
seconds
•
lowKilobytes —Lower range of the lifetime in kilobytes; in the range
100000–4294967295 KB; default value is 100000
•
highKilobytes —Higher range of the lifetime in kilobytes; in the range
100000–4294967295 KB; default value is 4294967295
•
txLowSeconds —Lower range of the lifetime in seconds; in the range 300–86400
seconds; default value is 3600
•
txHighSeconds —Higher range of the lifetime in seconds; in the range 300–86400
seconds; default value is 86400
1213 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: L Commands