Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 511 / 1502

crc
Syntax crc { 16 | 32 | none }
no crc
Release Information Command introduced before JunosE Release 7.1.0.
Description Sets the size of the cyclic redundancy check. CRC is an error-checking technique that
uses a calculated numeric value to detect errors in transmitted data. 16 and 32 indicate
the number of check digits per frame that are used to calculate the FCS. Both the sender
and receiver must use the same setting. The default value is 16. The
no version restores
the value to the default.
Options 16—Specifies CRC-16, which transmits streams of 8-bit characters and generates 16-bit
check bits per frame
•
•
32—Specifies CRC-32, which transmits longer streams at faster rates and therefore
provides better ongoing error detection
•
none—Disables CRC checking
Mode Interface Configuration
467 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: C Commands