Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 224 / 1502

atm pvc
Syntax To create a PVC on an ATM interface when using the aal5snap , aal5autoconfig , or
aal5mux ip encapsulation type:
atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]
[ oam [ seconds | cc [ segment | end-to-end ] { source | sink | both } ] ]
[ inArp [ minutes ] ]
no atm pvc vcd
To create a PVC on an ATM interface when using the aal5all , aal0 , or ilmi encapsulation
type:
atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]
no atm pvc vcd
To use a profile to apply encapsulation and traffic-shaping parameters to a bulk range
of PVCs configured for a dynamic ATM 1483 subinterface:
atm pvc encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ] [oam seconds ]
no atm pvc
Release Information Command introduced before JunosE Release 7.1.0.
Description From Interface Configuration or Subinterface Configuration mode, creates a PVC on an
ATM interface. The
no version removes the specified PVC.
From Profile Configuration mode, applies encapsulation, traffic-shaping, and OAM
parameters to the range of PVCs configured on a static ATM AAL5 interface for use by
a dynamic ATM 1483 subinterface. The
no version restores the default service type, UBR,
on the VC range.
NOTE: The optional peak, average, and burst parameters configure traffic-shaping
parameters for the circuit. The allowable traffic-shaping features and range
specifications depend on the line module capabilities.
Options
•
vcd —Virtual circuit descriptor that is an identifier for the VC in other commands; in the
range 1–2147483647
•
vpi —Virtual path identifier of this PVC. The allowable numeric range depends on the
line module capabilities and current configuration. The VPI and VCI cannot both be
set to 0; if one is 0, the other cannot be 0.
•
vci —Virtual circuit identifier of this PVC. The allowable numeric range depends on the
line module capabilities and current configuration. The VPI and VCI cannot both be
set to 0; if one is 0, the other cannot be 0.
Copyright © 2010, Juniper Networks, Inc. 180
JunosE 11.2.x Command Reference Guide A to M