Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 61 / 1502

Table 4: Interface Types and Specifiers for E120 Router and E320
Router
(continued)
Example Interface Specifier Description Interface Type
sonet 3/0/0 slot / adapter / port
• slot —Number of the chassis slot in the range
0–5 (E120 router) and 0–5 or 11–16 (E320
router)
• adapter —Identifier for the IOA within the
chassis slot, either 0 or 1, where:
• 0 indicates that the IOA is installed in the
right IOA bay (E120 router) or the upper IOA
bay (E320 router).
•
1 indicates that the IOA is installed in the
left IOA bay (E120 router) or the lower IOA
bay (E320 router).
• port —Port number on the IOA
Section layer
of a
SONET/SDH
interface sonet – section
layer
tenGigabitEthernet
4/0/1.20 slot / adapter / port [. subinterface1 [. subinterface2
] ]
• slot —Number of the chassis slot in the range
0–5 (E120 router) and 0–5 or 11–16 (E320
router)
• adapter —Identifier for the IOA within the
chassis slot. 0 indicates that this a full-height
IOA.
• port —Port number on the IOA
The meaning of the subinterface variables
depends on the configuration context. You can
configure 10-Gigabit Ethernet interfaces with or
without VLANs.
• VLANs:
• subinterface1 —Number of the VLAN
subinterface in the range 1–2147483647;
no more than 4096 VLAN subinterfaces
per 10-Gigabit Ethernet physical port
•
subinterface2 —When using PPPoE, the
number of the PPPoE subinterface in the
range 1–2147483647; no more than 16,000
PPPoE subinterfaces per 10-Gigabit
Ethernet line module
• No VLANs:
•
subinterface1 —When using PPPoE, the
number of the PPPoE subinterface in the
range 1–2147483647; no more than 16,000
PPPoE subinterfaces per 10-Gigabit
Ethernet line module
• subinterface2 —Not used
IEEE 802.3ae
10-Gigabit
Ethernet
(GE)
interface tenGigabitEthernet
17 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Command Reference Topics