Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 747 / 1502

inarp
Syntax inarp [ frequency ]
no inarp
Release Information Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
Description In ATM VC Configuration mode, enables Inverse ARP (InARP) on an ATM PVC that resides
on an ATM 1483 NBMA subinterface. Optionally, you can specify the InARP refresh rate.
The
inarp command is valid only for data PVCs configured with aal5snap encapsulation;
you cannot use this command for data PVCs with other encapsulation types or for control
(ILMI or signaling) PVCs. The
no version restores the default behavior, which disables
InARP.
In ATM VC Class Configuration mode, enables InARP as part of a VC class definition that
you assign to an ATM data PVC. The
no version restores the default behavior, which
disables InARP, in the VC class.
Options
•
frequency —InARP refresh rate in minutes, in the range 1–60; default value is 15
Mode ATM VC Configuration, ATM VC Class Configuration
703 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands