Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 245 / 1502

auto-configure
Syntax auto-configure upperInterfaceType [ lockout-time { minValue maxValue | none } ]
no auto-configure upperInterfaceType [ lockout-time ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Specifies the type(s) of dynamic encapsulations that are accepted or detected by the
static ATM 1483 interface. Optionally, specifies the lockout time range for the
encapsulation type. You can enter this command repeatedly in Subinterface Configuration
mode. The
no version terminates detection of the specified encapsulation type or, if the
lockout-time keyword is specified, restores the lockout time range to its default values.
NOTE: Encapsulation type lockout is available for bridged Ethernet, IP, PPP, and PPPoE
encapsulation types.
Options upperInterfaceType—One of the following dynamic encapsulation types:
•
•
bridgedEthernet
•
ip
•
ppp
•
pppoe
•
minValue —Minimum lockout time in the range 1–86400 seconds (24 hours); default
value is 1 second
•
maxValue —Maximum lockout time in the range 1–86400 seconds (24 hours); default
value is 300 seconds (5 minutes)
•
none—Disables lockout for the specified dynamic encapsulation type
Mode Interface Configuration, Subinterface Configuration
201 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: A Commands