Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1384 / 1502

from the remote PE; any out of order packets are dropped, regardless of whether
sequencing is configured.
•
no-sequencing—Specifies that the sequencing number in the control word is set to
zero, instructing the remote PE router to not attempt to detect out-of-order packets;
has no effect if no control word is sent in the packets.
•
relay-format ethernet—Specifies that the router uses Ethernet signaling and
encapsulation, which causes the VLAN interface to appear as an Ethernet interface to
the other side of the connection; enables a VLAN interface on one side of an MPLS
tunnel to communicate with an Ethernet or a bridged Ethernet interface on the other
side of an MPLS tunnel. The VLAN tag is not included in the MPLS encapsulation. This
option is not available on serial or POS interfaces for HDLC layer 2 circuits. It is available
only on VLAN interfaces
•
relay-format frame-relay—Specifies that the router uses legacy (pre-RFC 4619) Frame
Relay pseudowire type value for signaling and encapsulation. Enables a router running
JunosE Software that supports the pseudowire type value defined in RFC 4619,
Encapsulation methods for transport of Frame Relay over MPLS Networks, to
interoperate with a router that uses the legacy (pre-RFC 4619) pseudowire type value.
This option is available on serial or POS interfaces for Frame Relay layer 2 circuits. It
is not supported on E120 and E320 routers.
•
relay-format ppp—Specifies that the router uses VC-type PPP signaling and PPP
encapsulation instead of VC-type HDLC signaling and HDLC encapsulation. The router
uses VC-type HDLC signaling and HDLC encapsulation by default. This option is
available only on serial and POS interfaces for HDLC layer 2 circuits.
•
relay-format vlan—Specifies that the router uses VLAN signaling and encapsulation.
This option is not available on serial or POS interfaces for HDLC layer 2 circuits. It is
available for VLAN interfaces.
Mode Global Configuration
Related Topics Configuring CE-Side Load Balancing for Martini Layer 2 Transport in the JunosE BGP and
MPLS Configuration Guide
•
Copyright © 2010, Juniper Networks, Inc. 1340
JunosE 11.2.x Command Reference Guide A to M