Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 793 / 1502

•
sourceQualifier —For UDP or TCP protocols, one of the following protocol-specific
classifier parameters. See Creating or Modifying Classifier Control Lists for IP Policy
Lists for details.
•
portOperator— One of the following Boolean operator keywords: lt (less than), gt
(greater than), eq (equal to), ne (not equal), or range (range of port numbers)
•
range—Single port number or a range of port numbers
•
destinationAddress —Destination address to match
•
destinationMask —Wild-card mask to apply to the destination address
•
destinationHostAddress —Destination host address to match
•
destinationQualifier —One of the following protocol-specific classifier parameters for
destination TCP or UDP ports, ICMP code and type, or IGMP type. The portOperator
and port range are used with TCP and UDP. The icmpType , icmpCode , and igmpType
parameters are used with ICMP and IGMP.
•
portOperator— one of the following Boolean operator keywords: lt (less than), gt
(greater than), eq (equal to), or ne (not equal), or range (range of port numbers)
(TCP and UDP only)
•
range—Single port number or a range of port numbers
•
icmpType —ICMP message type (ICMP only)
•
icmpCode —ICMP message code (ICMP only)
•
igmpType —IGMP message type (IGMP only)
•
tcpQualifier —TCP flags classification parameters
•
tcpFlag —For TCP only; a logic equation that specifies flag bit values; ! means logical
NOT and & means logical AND; use any of the following flag names:
•
ack—0x10
•
fin—0x01
•
push—0x08
•
rst—0x04
•
syn—0x02
•
urgent—0x20
•
ipFlags —Logic equation that specifies flag bit values; ! means logical NOT and & means
logical AND; use any of the following flag names:
•
dont-fragment—0x02
•
more-fragments—0x01
•
reserved—0x04
749 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands