Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1414 / 1502

mpls ldp vpls neighbor
Syntax [ no ] mpls ldp vpls vplsName neighbor ipAddress
Release Information Command introduced in JunosE Release 8.2.0.
Description Configures the remote VPLS edge (VE) device address of a neighbor in the VPLS domain
in which the VPLS instance participates. The specified VPLS instance must use LDP as
the signaling protocol. If either or both LDP or MPLS are not configured on the current
virtual router, issuing this command creates the LDP and MPLS configurations
automatically. The
no version deletes the neighbor from the VPLS domain.
The mpls ldp vpls neighbor command is not valid for a VPLS instance that uses BGP as
the signaling protocol. To configure a VPLS instance with BGP signaling, use the bridge
vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls site-range
commands.
Options vplsName —Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
•
•
ipAddress —IP address of a neighbor in the VPLS domain
Mode Global Configuration
Related Topics Configuring LDP Signaling for VPLS in the JunosE BGP and MPLS Configuration Guide
•
Copyright © 2010, Juniper Networks, Inc. 1370
JunosE 11.2.x Command Reference Guide A to M