Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1051 / 1502

ipv6 access-list
Syntax Extended IPv6 access list:
ipv6 access-list accessListName { permit | deny } { srcIPv6Prefix |
host srcIPHost | any } { dstIPv6Prefix | host dstIPHost | any } [ log ]
no ipv6 access-list accessListName [ { permit | deny } { srcIPv6Prefix |
host srcIPv6Host | any } { dstIPv6Prefix | host dstIPv6Host | any } [ log ] ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Defines an IPv6 access list. The extended access list enables you to specify a destination
address or host, precedence, and type of service. Imposes an implicit last rule of “ deny
ip any any” to deny all routes that do not match previous rules in the access list. The
no
version removes the IPv6 access list, the specified entry in an access list, or the log for a
specified entry.
Options
•
accessListName —String of up to 32 alphanumeric characters
•
permit—Permits access if the conditions are matched
•
deny—Denies access if the conditions are matched
•
srcIPv6Prefix— Source IPv6 address and mask length from which the packet is being
sent
•
srcIPv6Host— Source host IPv6 address; assumes a mask length of 128
•
any — Creates an address of :: with a mask length of 0
•
dstIPv6Prefix —Destination IP address and mask length
•
dstIPv6Host —Destination host IPv6 address to which the packet is being sent
•
log—Logs an Info event into the ipAccessList log whenever the access-list rule is
matched
Mode Global Configuration
1007 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands