Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1019 / 1502

ip vrrp icr-partition svlan-list explicit
Syntax ip vrrp vrid icr-partition svlan-list-explicit [ svlanIdValue vlanIdValue ] *
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition svlan-list-explicit [ svlanIdValue vlanIdValue ] *
Release Information Command introduced in JunosE Release 10.3.0.
Description Adds an S-VLAN range and VLAN range to the ICR partition. You can assign only unique
S-VLAN range and VLAN range to the partition. If you attempt to assign a previously
assigned S-VLAN range and VLAN range to the ICR partition, the router displays an error
message. You can assign S-VLAN range and VLAN range only if you have selected S-VLAN
based grouping by using the
ip vrrp icr-partition group command. The no version deletes
the S-VLAN range and VLAN range from the ICR partition.
NOTE: You can use the listed optional parameters only when you add a S-VLAN, VLAN
pair to the ICR partition. You cannot modify an existing subinterface using these
parameters. You can specify the optional parameters in any order.
Options
•
vrid —VRID identifier; a number in the range 1–255
•
svlanIdValue —S-VLAN identifier; a number in the range 0–4095
•
vlanIdValue —VLAN identifier; a number in the range 0–4095
•
use-default-mac —Configures the S-VLAN range and VLAN range to use the default
MAC address. By default, the router assigns the VRRP media access control (MAC)
address to all subinterfaces of the ICR partition.
•
control-interface —Controls traffic on a subinterface that is part of a backup partition.
When you use this option, the router changes the state of the corresponding
subinterface to Admindown. When the subinterface is in Admindown state, the router
blocks all traffic to the interface. However, the router does not block advertisements
as long as VRRP is running on a separate subinterface. The router changes the state
of the subinterface from Admindown to Up when the state of the partition changes
from backup to master.
•
advertise-mac —Enables the subinterface to transmit GARP advertisements when the
partition moves from backup state to master state. By default, GARP advertisements
are blocked on a subinterface.
Mode Interface Configuration, Subinterface Configuration
Related Topics Grouping ICR Subscribers Based on S-VLAN IDs
•
•
Configuring an ICR Partition
975 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands