Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 1432 / 1502

mpls-relay atm vpi-range vci-range
Syntax [ no ] mpls-relay atm vpi-range vpiStart vpiEnd vci-range vciStart vciEnd
Release Information Command introduced in JunosE Release 10.2.0.
Description Configures a single virtual path identifier (VPI)/virtual circuit identifier (VCI) range of
ATM VCs whose cells need to be transported on the single pseudowire. You can configure
this command on the ATM port only after you associated a pseudowire with the port by
using the
mpls-relay or route interface tunnel command. When you run the mpls-relay
or route interface tunnel command, no default VPI/VCI range is configured. You must
specifically configure the VPI/VCI ranges. You can use this command only on an ATM
port (ATM AAL5 over ATM major interface). The VPI/VCI values that are not part of the
specified range can be used for other existing applications. The
no version removes the
configured VPI/VCI range.
NOTE: The total number of VCs configured with the mpls-relay atm vpi-range vci-range
command cannot exceed the maximum ATM VC capacity of the line module you are
using. For details about the ATM VC capacity of supported line modules, see JunosE
Release Notes, Appendix A, System Maximums.
Options
•
atm—Configures ATM interface parameters for MPLS cross-connect. A local
cross-connect enables the router to function as a layer 2 switch. It operates with any
supported layer 2 service
•
vpiStart —Starting virtual path identifier (inclusive) of the VC subrange you are
configuring; number in the range 0–255
•
vpiEnd —Ending virtual path identifier (inclusive) of the VC subrange you are configuring;
number in the range 0–255
•
vciStart —Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring; number in the range 1–65535
•
vciEnd —Ending virtual circuit identifier (inclusive) of the VC subrange you are configuring;
number in the range 1–65535
Mode Interface Configuration
Related Topics Multiple ATM Virtual Circuits over a Single Pseudowire Overview and Multiple ATM Virtual
Circuits over a Single Pseudowire Example in the JunosE BGP and MPLS Configuration
Guide
•
Copyright © 2010, Juniper Networks, Inc. 1388
JunosE 11.2.x Command Reference Guide A to M