Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Command Reference Manual

Page: 783 / 1502

ip as-path access-list
Syntax ip as-path access-list accessListName { permit | deny } pathExpression
no ip as-path access-list accessListName [ { permit | deny } pathExpression ]
Release Information Command introduced before JunosE Release 7.1.0.
Description Defines a BGP-related access list. You can specify an access list filter on both inbound
and outbound BGP routes. Each filter is an access list based on regular expressions. If
the regular expression matches the representation of the AS path of the route as an ASCII
string, then the permit or deny condition applies. The AS path does not contain the local
AS number. The
no version removes a single access list entry if permit or deny and a
pathExpression are specified. Otherwise, the entire access list is removed.
Options
•
accessListName —Name of the access list; a string of up to 32 characters
•
permit—Permits access for matching conditions
•
deny—Denies access to matching conditions
•
pathExpression —Regular expression describing the AS paths to be matched
Use a sequence of one or more elements, each of which is either an AS number or one
of the following punctuation characters:
^ start of the path
$ end of the path
{ start of an AS_SET
} end of an AS_SET
( start of an AS_CONFED_SET or AS_CONFED_SEQ
) end of an AS_CONFED_SET or AS_CONFED_SEQ
Use the following regular expression metacharacters to match individual elements:
. matches any single element
* matches zero or more occurrences of any element
+ matches one or more occurrences of any element
[ ] matches any elements enclosed between brackets ([ ])
- hyphen; used within brackets to specify a range of AS numbers
739 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: I Commands