Multitron - Operating Manual
Operation
20 August 2020
Page
91
of
158
Rotation speed (
RPM
)
The parameter
rotation speed
(
RPM
) belongs to the standard scope
of delivery.
When entering the setpoint value for the rotation speed it is shown
in rpm (min
-1
) with an accuracy of one whole number.
INFORMATION
The highest rotation speed allowed depends on the throw, the po-
sition of the device in a stack and the load on the tray (mass).
Humidity (
Humid
)
The parameter
humidity
(
Humid
) does not belong to the standard
scope of delivery and therefore it is only available if the according op-
tion is installed.
When entering the setpoint value for the relative humidity it is shown
in percent with an accuracy of one decimal place.
If the parameter is not installed, the display remains empty.
Parameter-specific display elements
The sign
Setpoint
lights up, when by tapping the
SET
key on the up-
per or lower operating panel the setpoint values for the parameters
can be entered.
The sign
High
or
Low
lights up, if the current value of a parameter is
above respectively below its setpoint value.
After a certain time span or when a critical value is reached an alarm
will be set off, because most probably an error or defect hinders the
device to reach or maintain the setpoint value in question.
The possible setpoints for the parameters
rotation speed
and
temper-
ature
can be limited in the settings menu. If an attempt is made to
enter a higher value, the message
bloc
appears.
