Multitron - Operating Manual
Operation
20 August 2020
Page
107
of
158
Parameters of any phase
Procedure
1.
Use the
TIMER
key to select the desired phase.
After taping the
TIMER
key once, the remaining time of
the active phase appears with the message
run
.
After tapping the
TIMER
key twice, the time entered for
the first phase (
Time 1
) appears.
After tapping the
TIMER
key three times, the time entered
for the second phase (
Time 2
) appears.
The selected phase is indicated by the sign
Phase 1
or
Phase 2
. If
this phase is not the active phase, then in addition the sign of
the active phase is blinking. In the example on the left the sec-
ond phase is active while the parameters for the first phase can
be changed.
2.
Use the
Select
key to select the desired parameters within the
phase chosen.
In the two alphanumeric display areas the setpoint values of the
selected pair of parameters are shown.
The sign
Setpoint
indicates, that a setpoint can be set.
3.
Tap the
Plus
or
Minus
key in the according setting key area to
set the new setpoint value.
The new setpoint value for the parameter appears on the ac-
cording alphanumeric display.
4.
Use the
Select
key to get to the next pair of parameters or quit
the parameter setting mode with the
TIMER
key.
5.
Tap the
Select
key to return to the normal operation mode of
the display.
7.5.6
Stopping the Timer Function
Turning off the timer function
If required, the timer function can be stopped at any time. Proceed as
follows:
Procedure
1.
Tap the
TIMER
key to select the timer function.
