Multitron - Operating Manual
Operation
Page
86
of
158
20 August 2020
7.3.2
Signs and Messages Regarding the Timer Function
In the upper and lower display area
All signs and symbols in connection with the timer information – ex-
cept the duration which needs to be entered – light up in blue.
In the upper display area the sign
Time 1
lights up, when within the
timer function (see below) the setpoint value for the duration of the
first phase (
Phase 1
) can be entered.
First, the message
OFF
appears, if the timer is not activated.
In a similar way but not at the same time, the according information
for the second phase (
Phase 2
,
Time 2
) is shown in the lower display
area.
On both alphanumeric displays the time for the timer function is
shown.
When entering a time between one minute (00:01) and 23 hours and
59 minutes (23:59) the units
h
and
min
light up.
When entering a time between 24 hours or one day (01:00) and the
maximum of 9 days and 23 hours (09:23) the units
days
and
h
light
up.
In the separate timer display area
In the separate timer display area there are the four signs
Timer
, a
symbol for
cycle
,
Phase 1,
und
Phase 2
.
The sign
Timer
indicates that either within the timer function the set-
points for the duration (
Time 1
and/or
Time 2
) can be entered or that
at least one timer has been activated.
The symbol for the
cycle
mode lights up in addition to the sign
Timer
as soon as two durations (
Time 1
and
Time 2
) have been entered and
both timers are activated. Then the device alters between the param-
eter setpoints of the first and the second phase in an endlessly re-
peated cycle.
/
The signs
Phase 1
and
Phase 2
indicate in which phase the device is
operating if both timers are active with different parameter settings.
They also indicate for which phase (
Time 1
or
Time 2
) the parameter
setpoints can be entered or the actual values of the parameters are
shown on the alphanumeric display.
