Multitron - Operating Manual
Operation
20 August 2020
Page
79
of
158
2.
Place the tray on the door slide rails.
3.
Push the tray between the guide rails over the front stop bar up
to the limit stop at the back of the incubation chamber. The tray
must audibly click into place behind the front stop bar.
4.
Check whether the tray is placed properly behind the front stop
bar.
5.
Device with 25 mm or 50 mm throw:
Close the device door.
When the door closes, the ejection levers lower and the tray is
lowered into the two cones. The tray is thus securely affixed to
the table.
6.
Device with 3 mm throw:
Ensure that the tray is correctly
snapped into the two conical plugs on the table.
7.
Device with 3 mm throw:
Insert the knurled screw and tighten
it by hand. Tighten the knurled screw so that it cannot come
lose during operation.
8.
Check whether the tray is securely affixed to the table.
ATTENTION
If the tray is not held in place securely on the table, the tray’s
movement may damage the interior of the device.
–
Do not start up the device unless the tray has been inserted
correctly and affixed securely.
–
If you are using a device with a 3 mm throw, make sure the
knurled screw is inserted and tightened correctly.
