Multitron - Operating Manual
Operation
20 August 2020
Page
115
of
158
7.7.9
Setting up Data Exchange via Ethernet
Top display:
OPt
,
EXTERN
and
Wireless
You can set whether and in which direction data can be sent via the
Ethernet interface. To do so, tap the
SET
key (the writing
Setpoint
appears) and then use the
ON/OFF
key to select the desired setting.
The following settings are possible:
Auto:
Send and receive data, i.e. information from the device
can be recorded but commands can also be sent to the device
(e.g. changes to the parameters).
on:
Only receive data, i.e. only data sent from the device can
be recorded.
OFF:
The Ethernet interface is deactivated; no communication
can take place.
7.7.10
Setting the Height Above Sea Level (Altimeter)
Top display:
ALti
and
CO
2
The digital CO
2
sensor GMP251 is pressure-dependent. To achieve
precise measuring results, the altitude of the device’s location can be
entered. To do so, tap the
SET
key (the sign
Setpoint
appears) and
then use the
Plus
or
Minus
key to set the altitude in meters.
Default value: 0
7.7.11
Activating or Deactivating the Door Alarm
Top display:
doAL
The device has a door alarm. This is triggered if the door is left open
for too long. To activate or deactivate the door alarm, tap the
SET
key (the sign
Setpoint
appears) and then use the
ON/OFF
key.
The time after which the alarm is triggered can be set. To do so, tap
the
SET
key again (the sign
Setpoint
appears) and then use the
Plus
or
Minus
key to set the desired time period (1-10 minutes).
