87
9.4 Program
Press [Menu]→[4](Program) to enter the program menu, as
shown in picture below:
Program
1.REM
1/2
2.MLM
3.Coord.Z
4.Area
5.Project
P1
Program
1.Roadway
2/2
P2
[F4]
9.4.1 Remote height (REM)
REM is adequate for measuring the target height when the
prism cannot be placed at the target point. Under ‘REM’ mode,
you can place the prism on any point along the plumb line of the
target point to obtain the height of target.
VD
Prism height
prism
P
Target point
C
There are two modes for ‘REM’ measurement: ‘Input TH’
and ‘without TH’. You can select ‘Input TH’ mode when you
need the altitude from ground to target, otherwise ‘without TH’
when you need the altitude from any reference point to target.
9.4.1.1 “Input T.H” Mode
Select “1. Input T.H” to enter the interface of “Height of
