50
Offset (Dist2)
Clear
B.S
Enter
Distance：
m
Input the distance, and press [Enter] to enter the interface of
“Offset -Begin”. You must aim at point “P0” to measure.After
measuring, press [ENT] to exit the interface to enter the interface
of “Offset-End”.
Offset-Begin
VZ:
Coord.
171°49′54″
T.H
Meas
Mode
HR:
299°33′47″
HD:
0.014 m
[ENT]
Offset-End
VZ:
Coord.
171°49′54″
T.H
Meas
Mode
HR:
299°33′47″
HD:
m
Aim at the end point, and press [ENT] after measuring. The
coordinates of measured points are displayed, as shown in
picture below:
Result
N:
-0.749
Save
Next P
Exit
E:
-2.026
Z:
1.000
m
m
m
◆
If you need the coordinate of ‘A0’ ,you should set the
height of prism as zero.
◆
If you need the coordinate of ‘A1’ ,you should set the
height of prism as the real height.
8.4 Offset (Plane)
This function is used to measure the point which can’t be
measured directly, such as the point on the edge of the plane.
Firstly, you should measure any three points (P1, P2, P3) to
