33
●
The number of point name in the system is added 1
automatically. If you want to modify point mane, code,
and target height, just press [Num.] or [Alph.], if don’t
just press [ENT] to save.
●
The system saves the record with a prompt “Finished”,
which disappears automatically after 0.5 seconds.
5.2 0set
Function: set the horizontal angle as 0 °00′00″.
●
Press [F2](0set);
●
Asking “Set 0?”, press [ENT] to set 0 or [ESC] to exit
this operation. In order to make sure the accuracy, you
may press [ENT] lightly.
5.3 Hset
Function: Set the horizontal angle as wanted angle.
●
Press [F3] to enter the interface of “Set HA” to set
horizontal angle ;
●
In the “DMS” of angle unit mode, if you want to
input “123°45′56″”
，
just input “123.4556” in the input
box. In the other angle unit mode , input normally, as
shown in picture below:
Set HA
Exit
Clear
B.S
Enter
HR:
123.4556
●
Press [ENT] to confirm the input, or [ESC] TO to
cancel. When over 360°, it will tip “Overtop!”
