GRAPHTEC FC5100A-100, User Manual

Page: 53 / 201

Preparing to Cut: Setting Conditions
53
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 40.
• If you wish to change another parameter:
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• If all of the parameters are set, press the ENTER key to register your setting.
T
O
C
HANGE THE
C
UTTER
S
PEED
• Press the F2 key to change SPEED. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 100. [1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, 100]
• If you wish to change another parameter:
• Press the F1 key to change FORCE.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• If all of the parameters are set, press the ENTER key to register your setting.
T
O
C
HANGE THE
C
UTTER
Q
UALITY
• Press the F3 key to change QUALITY. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 8. The smaller the value, the higher the quality. When you select a speed that
is faster than 60, you cannot select quality. At that time an “xx” appears.
• If you wish to change another parameter:
• Press the F1 key to change FORCE.
• Press the F2 key to change SPEED.
SET ............ 14
CONDITION 1 ........ 30
4
CB09Ux ... 0
SET ............ 14
CONDITION 1 ........ 30
4
CB09Ux ... 0