GRAPHTEC FC5100A-100, User Manual

Page: 185 / 201

Options: FC5100A Pounce Tool Manual
185
3 When the pouncing tool has been properly mounted, tighten the screw.
Select Pounce Tool
from the Menu
• Press the function key [F1] through [F4] corresponding to the number of the
group whose registered tool you wish to change.
• Press the CONDITION key to select the tool.
• Press the F4 key to select the tool you wish to use.
• Press the RIGHT or LEFT ARROW key to scroll through the tool selection until
you select POUNCE to use the pouncing pen.
• Press the ENTER key to select POUNCE.
Pounce Conditions
To change the setting of a group of conditions, press the function key [F1] to
[F4] corresponding to the number of the group you wish to change. For example,
press the F4 key to select CONDITION 8. If CONDITON 4 appears, then press the
F4 key again to select CONDITION 8.
• Press the CONDITION key to access the condition menu.
• Press the NEXT key to cancel the condition where you are currently set and
return to the main menu.
T
O
C
HANGE THE
P
OUNCE
F
ORCE
• Press the F1 key to change FORCE. The blinking cursor indicates that you can
change its setting
• Press the UP or DOWN ARROW key to raise or lower the numeric value 1-40.
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• Press the ENTER key to register your setting.
T
O
C
HANGE THE
P
OUNCE
S
PEED
• Press the F2 key to change SPEED. The blinking cursor indicates that you can
change its setting.
Pen stopper
Rim