GRAPHTEC FC5100A-100, User Manual

Page: 31 / 201

Cutters and Holders: Replacing the Cutter Blade
31
Replacing
Ceramic & Sap-
phire Blades
For the PHP31-CB15:
1 Turn the blade length adjustment knob
counterclockwise.
2 Remove Holder B.
3 Remove the blade from Holder A.
4 Point the tip of Holder A downward.
5 Insert new blade.
6 Make sure blade is inserted straight. Gen-
tly tap the plunger to correct angled blades.
7 Point the tip of Holder A downward.
8 Attach the holder cap.
9 Turn the blade length adjustment knob
clockwise until the blade tip is visible.
NOTE: If the blade does not rotate smoothly or
the blade falls off after attaching the cut-
ter pen to the pen carriage, the inside of
the holder is insufficiently lubricated.
Apply the provided grease to the three
(3) points indicated by arrows in the fig-
ure above.
NOTE: The blades can also be replaced from
the front of the plunger.
1. Turn the blade adjustment knob fully clockwise.
2. Remove the blade from the front of the plunger.
3. Replace the blade.
4. Turn the blade adjustment knob counterclockwise.
CAUTION: The cutter must be properly
seated (the pen holder is
engaged on the flange)
before tightening the screw. Flange
Bracket to hold pen