GRAPHTEC FC5100A-100, User Manual

Page: 139 / 201

Background Settings: Background Settings for GP-GL
139
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
NOTE: This menu only appears when the 2 Pen option is installed.
Initial Blade Con-
trol Position (INI-
TIAL BLADE
CONTROL)
This function specifies the position at which initial blade control is performed
(for more information about initial blade control see Adjusting the Blade Offset
Angle .)
When 2mm BELOW is selected, initial blade control is performed 2mm below the
starting point of cutting.
When OUTSIDE is selected, initial blade control is performed outside of the
effective cutting area.
• Press the F3 key to select 2mm BELOW or press the F4 key to select OUTSIDE.
A blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Length Unit
This selection enables you to set the unit for coordinates appearing on the dis-
play panel to either units of millimeters or inches.
INITIAL BLADE
CONTROL POSITION
2mm BELOW .
OUTSIDE .
INITIAL BLADE
CONTROL POSITION
2mm BELOW .
OUTSIDE .
LENGTH UNIT
METRIC .
INCH .