GRAPHTEC FC5100A-100, User Manual

Page: 102 / 201

Advanced Functions and Settings: AUTO REG. MARK - Auto Registration Mark Sensor
102
• If you press the F3 key (AUTO), sensing begins from the current pen position.
Use the POSITION key to move the pen tip to the shaded area in the following
diagrams, and then press the F3 key.
• If you press the F4 key (MANUAL), the following message is displayed. Use the
POSITION key to move the pen tip to MARK 1, and then press the ENTER key.
When the ENTER key is pressed, the plotter will start scanning for the registra-
tion mark.
• When the four points have been scanned, the display changes to the following
(only displayed if OFF has been selected for DISTANCE ADJUST). The mea-
sured value for the distance between points 1 and 2 is shown on the 3rd row.
Set the actual distance on the 4th row.
Press the RIGHT or LEFT ARROW key to move the cursor. Press the UP or
DOWN arrow key to increase or decrease the number for the distance value.
Point 3
Point 3
Point 4 Point 2
Point 4 Point 2
Pattern 1
Media
feed
direction
Pattern 2
Point 1
(the desired Origin Point)
Point 1
(the desired Origin Point)
Move the pen tip within this area
Move the pen tip within this area
MOVE TO MARK 1 *
USE THE POSITION KEY *
TO MOVE THE PEN AND *
THEN PRESS ENTER. *
DISTANCE
POINT 1-2
00303.5 mm .
OK? .......... 00303.5 mm .