GRAPHTEC FC5100A-100, User Manual

Page: 143 / 201

Background Settings: Background Settings for HP-GL
143
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Model No.
Response
(MODEL EMU-
LATED)
When the HP-GL

command mode is selected, this function selects the plotter’s
response to an “OI” request sent from the computer.
When 7550 is selected, the
plotter’s response is 7550. When 7586 is selected, the plotter’s response is 7586.
• Press the F3 key to select 7550 or press the F4 key to select 7586. A blinking
cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Condition Prior-
ity
This function determines the priority of programmed versus manual cutting con-
ditions.
When MANUAL is selected, commands specifying cutting conditions from the
computer are ignored and the cutting conditions can only be set at the control
panel. The registered conditions are retained in the plotter’s internal memory
even while the plotter is turned off.
When PROGRAM is selected, the cutting conditions can be set either at the
plotter’s control panel or by command input from the computer. When the plotter
is turned off, the registered conditions by command input from the computer are
not retained. The registered conditions by the plotter’s control are retained.
MODEL EMULATED
7550 .
7586 .
CONDITION PRIORITY
MANUAL .
PROGRAM .