Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 91 / 700

Chapter 2: Get Started
Tutorial: Do a Bi-directional SmartLoop Test
55
Step 3: Turn Off the Auto Save Function
For this tutorial, you will manually save the test results.
3-1
On the home screen, tap the
Next Fiber A ID/Next Fiber B ID
panel.
3-2
On the
CHANGE ID
screen, tap the
Auto Save
control to make
it show
Off
.
3-3
Stay on this screen to do the next step.
Step 4: Enter IDs for the Fibers
4-1
On the
CHANGE ID
screen, tap the
FIBER A ID:
panel.
4-2
Enter an ID for fiber A, then tap
DONE
twice.
The
CHANGE ID
screen shows the ID you entered for fiber A.
For the
Fiber B ID
, the tester increments the
Fiber A ID
by one.
4-3
Tap
DONE
to save the IDs. If you see a message about an ID
that is not in the list, tap
YES
.
Step 5: Set Up Launch Fiber Compensation
5-1
On the home screen, tap
SET COMP
.
5-2
On the
SET LAUNCH METHOD
screen, make sure that
SmartLoop
is selected.
5-3
Clean and inspect the OTDR port and the connectors on the
three launch cords.
5-4
Make the connections shown in Figure 16.
5-5
Tap
SET
.
5-6
When the
SET LAUNCH COMP
screen shows, make sure the
tester shows the correct distances for the end of the launch
cord and the start of the tail cord. See Figure 17.
(continued)