Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 632 / 700

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
596
GPU21.EPS
Figure 211. How to Remove the Battery
Replace the Tip on a DSX-PLA004 Connector
Over time, the gold plating on the DSX-PLA004 adapter’s RJ45
connector’s contacts becomes worn. This can cause test result
margins to shrink. Damage to the contacts can also cause
problems with tests.
When margins begin to shrink, or if the RJ45 tip is damaged,
replace the tip with a new one. New tips are available in the
DTX-PLA002PRP replacement parts kit. The connector’s latch can
also become worn, so the parts kit also includes replacement
latches.
To replace the tip and latch
1
Remove the adapter from the tester.
2
Use a Phillips screwdriver to loosen the screw on the
connector case; then remove and replace the tip or latch as
shown in Figure 212.
3
Make sure that the conductive washer is on the case screw as
shown below.
4
Reassemble the connector case, then tighten the screw.
A
B
C
Model VERSIV-BATTERY
OFF