Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 623 / 700

Chapter 20: Maintenance
See Information About the Tester
587
See Information About the Tester
To see information about your tester and attached modules and
adapters
On the home screen, tap the
TOOLS
icon, then tap
Version
Information
. See Figure 208.
To see information about a remote tester
Use DSX or CertiFiber Pro modules and patch cords to connect the
main and remote testers together (see Figure 4 on page 21), then
tap
REMOTE
on the
Version Information
screen.
Refer to Figure 208:

If the tester is connected to a wired network through the
Ethernet jack on the side of the tester, the IP address of the tester
shows.

The serial number and the software and hardware versions of
the device.
 The versions of the databases for test limits and cable types.
These databases are part of the software version installed in the
main tester.
 If a remote tester is connected to the main tester, tap
REMOTE
to
see information about the remote tester.

If a link interface adapter is attached to the tester, you can tap
ADAPTER
to see this information about the adapter:

Serial Number
and the
Hardware
version of the adapter.

Autotest Count
is the number of Autotests done with the
adapter. You can use this count to monitor the wear on
the adapter’s jack or plug.

Current Series
is an Autotest count that you can reset. To
reset the counter, tap
Reset Series
.