Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 585 / 700

Chapter 17: Use Projects
How to Make ID Sets
549
ROOM 17 FIBER 2B
ROOM 18 FIBER 1A
ROOM 18 FIBER 1B
ROOM 18 FIBER 2A
ROOM 18 FIBER 2B
Each project can have up to 5000 IDs. If an ID set does not have a
Last ID
, the tester counts the set as one ID. An ID can have a
maximum of 60 characters.
To make an ID set
Note
When you make an ID set, the tester saves it in the
project shown on the home screen.
1
On the home screen, tap the
PROJECT
panel.
2
On the
PROJECT
screen, tap
NEW ID SET
.
3
On the
CABLE ID SETUP
screen, tap the
First ID
panel, then
use the keyboard to enter the first ID for the set.
4
Tap the
Last ID
panel, use the keyboard to enter the last ID for
the set, then tap
DONE
.
Note
If you do not enter a Last ID, the tester uses the
first ID as the Next ID and increments that ID each
time you save a result. See “To Make ID Sets with
International Characters” on page 550.
5
To use the IDs for fiber tests, tap
Fiber
under
Select Media
,
then select the necessary tests. See Figure 198 on page 526.
6
To see the ID set, tap
REVIEW
.