Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 256 / 700

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
220

RESULTS
: Tap
RESULTS
to see and manage the results that are
saved in the tester.

To upload results to LinkWare Live, tap
SYNC
. See Chapter 18.

TEST
: Tap
TEST
to do the test shown in the test setup panel.

The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and the tests you
selected on the
CABLE ID SETUP
screen to calculate this
percentage. See Figure 198 on page 526.
% Tested
does not
show if your project contains only a
Next ID
list. See “To Make
ID Sets with International Characters” on page 550 for more
information about the
Next ID
list.
 The type of module attached to the tester. For the blank
module that comes with the FI-7000 kit,
HOME
shows.
 The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 566.
Settings for FiberInspector Tests
Table 10 gives descriptions of the settings for FiberInspector tests.
To set up a project, which includes the settings in Table 10, cable
IDs, and operator names, see Chapter 17.
To set up a FiberInspector test
1
On the home screen, tap the test setup panel.
2
On the
CHANGE TEST
screen, select a FiberInspector test, then
tap
EDIT
.
Or to set up a new FiberInspector test, tap
NEW TEST
. If no
module is installed, the
MODULE
screen shows. Tap
FiberInspector
or
FI-7000
.