Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 86 / 700

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
50
Step 6: Do an Autotest in Smart Remote Mode
W
Caution
If you disconnected a test reference cord from the
output of the tester or remote, you must set the
reference again to make sure your measurements
are reliable.
6-1
On the
SET REFERENCE
screen, when the set reference or
TRC verification procedure is completed, tap
NEXT
to see
how to connect to the link under test.
6-2
Clean and inspect all the connectors.
6-3
Make the connections to do the test on the fiber link, as shown
on the screen and in Figure 13 above
Fiber Link Test
, then tap
DONE
.
6-4
Tap
TEST
on the main tester or press

on the main or
remote tester.
6-5
Halfway through the test, the tester tells you to switch the
input and output fibers for the bi-directional test.
W
Caution
Switch the connections at both ends of the patch
panel or fiber under test, not at the tester's and
remote’s ports. If you disconnect a test reference
cord from an output port on the tester or remote,
the reference value will be unreliable.