Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 577 / 700

Chapter 17: Use Projects
How to Change Settings as You Use a Project
541
Step 7: Monitor the Status of Your Project
The home screen shows
% Tested
, which is the percentage
completed of the total number of tests you must do for the
project.
In this tutorial you set up IDs for 42 tests total (see page 534), and
have completed these tests:
 One Autotest on twisted pair for ID B-00

Four OTDR tests:
End 1
and
End 2
for each fiber ID 1A and 1B
 Two Loss/length tests: one for each fiber ID 1A and 1B

Total tests completed: 7

% Tested
on the home screen shows
17%
(7 tests completed
out of 42 total for the project)
To see the IDs that do not have results for a test, tap the
Next ID
panel on the home screen. If the tester is in
Smart Remote
mode,
next tap the
Input Fiber ID
or
Output Fiber ID
window.
For a list of fiber IDs, the ID list under
IDs Untested
shows the IDs
that do not have results for the
End
selected at the top of the
screen and the
Test Type
shown.
For a list of copper IDs, the ID list shows the IDs that you have not
used.
How to Change Settings as You Use a Project
To Change the ID
Sometimes you must use an ID that is not the next ID in the set, an
ID that is not in the ID set, or an ID you used before. You can
change the ID on the
CHANGE ID
screen before you do a test or
enter the ID on the
SAVE RESULT
screen after you do a test.