Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 85 / 700

Chapter 2: Get Started
Tutorial: Certify Fiber Optic Cabling
49
Step 5: Measure the Loss of the Test Reference Cords You
Will Add
W
Caution
If you disconnected a test reference cord from the
output of the tester or remote, you must set the
reference again to make sure your measurements
are reliable.
5-1
On the
SET REFERENCE
screen, when the reference procedure
is completed, tap
NEXT
.
5-2
Disconnect the test reference cords from the INPUT ports on
the tester and remote, then use test reference cords and
adapters to make the connections to verify the TRCs, as shown
on the screen and in Figure 13 above
TRC Verification
.
5-3
Tap
TRC VERIFICATION
. The tester measures and saves the loss
of the test reference cords you added.
If the tester shows a warning, clean and inspect the
connectors on the TRCs in the path that has too much loss,
then set the reference and do the TRC verification again.