Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 563 / 700

Chapter 17: Use Projects
Tutorial: Make a New Project
527

Select Media:
Select the type of module,
Copper
or
Fiber
, that
you will use when you use this ID set. For
Fiber
, also select one or
more fiber tests.
Notes
You can use an ID set only for results from the
media type you selected under Select Media.
The Select Media section does not show for ID sets
that do not have a Last ID. You can use these ID sets
for copper or fiber results.
 Tap
IMPORT
to use an ID set that you downloaded to the tester
from LinkWare PC software.

Tap
REVIEW
to see the
CABLE ID REVIEW
screen, which shows
the ID set an the total number of IDs. See “How to Make ID Sets”
on page 548.
Note
The REVIEW button is not available if you do not
enter a Last ID.

SAVE
: To save the ID set, tap
SAVE
.

When you select
Fiber
media for tests that use a CertiFiber Pro
or OptiFiber Pro module, select the tests that are necessary for
each fiber in the ID set.
For example, you can specify that you must do a
Loss/Length
test and a
FiberInspector
test for each ID. After you do both
tests for all the IDs in the set, the tester shows
100% Tested
on
the home screen. If no IDs include FiberInspector results, the
tester shows
50%
. To see the IDs that need FiberInspector
results, select a
FiberInspector
test in the project, then look at
the list under
FiberInspector IDs Untested
on the
CHANGE ID
screen (item

in Figure 199).