Extreme Networks EAS 200-24p Switch, Manual

Page: 572 / 908

Chapter 37: Multiple Spanning Tree Protocol (MSTP) Command List
Extreme Networks EAS 200-24p Switch CLI Manual
572
config stp ports
Description
This command can configure all the parameters of ports, except for Internal Path Cost and Port Priority.
Format
config stp ports <portlist> {externalCost [auto | <value 1-200000000>] |
hellotime <value 1-2> | migrate [yes | no] | edge [true | false | auto] | p2p
[true | false | auto] | state [enable | disable]| restricted_role [true |
false] | restricted_tcn [true | false] | fbpdu [enable | disable]}
Parameters
●
<portlist> - Enter a list of ports used for the configuration here.
●
external_cost - (Optional) The path cost between MST regions from the transmitting Bridge to the
CIST Root Bridge. It is only used at CIST level.
●
auto - Specifies that the external cost value will be set to automatic.
●
<value 1-200000000> - Enter the external cost value here. This value must be between 1 and
200000000.
●
hellotime - (Optional) The default value is 2 . This parameter is for MSTP version. For STP and
RSTP version, uses the per system hellotime parameter.
●
<value 1-2> - Enter the hello time value here. This value must be between 1 and 2.
●
migrate - (Optional) Operation of management in order to specify the port to send MSTP BPDU for
a delay time.
●
yes - Specifies that the MSTP BPDU for a delay time will be sent.
●
no - Specifies that the MSTP BPDU for a delay time will not be sent.
●
edge - (Optional) To decide if this port is connected to a LAN or a Bridged LAN.
●
true - Specifies that the specified port(s) is edge.
●
false - Specifies that the specified port(s) is not edge.
●
auto - In auto mode, the bridge will delay for a period to become edge port if no bridge BPUD is
received. The default is auto mode.
●
p2p - (Optional) To decide if this port is in Full-Duplex or Half-Duplex mode.
●
true - Specifies that the port(s) is in Full-Duplex mode.
●
false - Specifies that the port(s) is in Half-Duplex mode.
●
auto - Specifies that the port(s) is in Full-Duplex and Half-Duplex mode.
●
state - (Optional) To decide if this port supports the STP functionality.
●
enable - Specifies that STP functionality on the port(s) is enabled.
●
disable - Specifies that STP functionality on the port(s) is disabled.
●
restricted_role - (Optional) To decide if this port not to be selected as Root Port. The default value is
false.
●
true - Specifies that the port can be specified as the root port.
●
false - Specifies that the port can not be specified as the root port.