Extreme Networks EAS 200-24p Switch, Manual

Page: 20 / 908

Chapter 1: Using the Command-Line Interface
Extreme Networks EAS 200-24p Switch CLI Manual
20
Enter the UserName and PassWord and press the Enter key after each to login and to display the CLI
input cursor - EAS 200-24p:admin#. This is the command line where all commands are input.
Setting the Switch’s IP Address
Each switch must be assigned its own IP Address, which is used for communication with an SNMP
network manager or other TCP/IP application (for example BOOTP, TFTP). The switch’s default IP
address is 0.0.0.0. You can change the default switch IP address to meet the specification of your
networking address scheme.
The switch is also assigned a unique MAC address by the factory. This MAC address cannot be
changed, and can be found on the initial boot console screen – shown below.
The switch’s MAC address can also be found in the Web management program on the switch
Information (Basic Settings) window on the Configuration menu.
The IP address for the switch must be set before it can be managed with the web-based manager. The
switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual
address assigned to the switch must be known.
Starting at the command line prompt, enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy . Where the x ’s represent the IP address to be assigned to the IP interface
named System and the y ’s represent the corresponding subnet mask.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z . Where the x ’s represent the
IP address to be assigned to the IP interface named System and the z represents the corresponding
number of subnets in CIDR notation.
The IP interface named System on the switch can be assigned an IP address and subnet mask which can
then be used to connect a management station to the switch’s Telnet or web-based management agent.
Boot Procedure V1.00.001
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : 00-04-96-52-83-83
H/W Version : A1
Please Wait, Loading V1.00.007 Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
Device Discovery .......................................... 100 %
Configuration init ........................................ 100 %