Extreme Networks EAS 200-24p Switch, Manual

Page: 179 / 908

config egress_access_profile
Extreme Networks EAS 200-24p Switch CLI Manual
179
- <value 0-255> - Enter the IGMP type traffic value here. This value must be between 0 and 255.
●
tcp - (Optional) Specifies that the following parameters configured will apply to the TCP
configuration.
●
src_port - Specifies that the rule will apply to a range of TCP source ports.
- <value 0-65535> - Enter the source port value here. This value must be between 0 and 65535.
●
mask - Specifies the TCP source port mask here.
- <hex 0x0-0xffff> - Enter the TCP source port mask value here.
●
dst_port - Specifies that the rule will apply to a range of TCP destination ports.
- <value 0-65535> - Enter the destination port value here. This value must be between 0 and
65535.
●
mask - Specifies the TCP destination port mask here.
- <hex 0x0-0xffff> - Enter the TCP destination port mask value here.
●
flag - (Optional) Specifies the TCP flag fields.
●
all - Specifies that the TCP flag field will be set to 'all'.
●
urg - Specifies that the TCP flag field will be set to 'urg'.
●
ack - Specifies that the TCP flag field will be set to 'ack'.
●
psh - Specifies that the TCP flag field will be set to 'psh'.
●
rst - Specifies that the TCP flag field will be set to 'rst'.
●
syn - Specifies that the TCP flag field will be set to 'syn'.
●
fin - Specifies that the TCP flag field will be set to 'fin'.
●
udp - (Optional) Specifies that the following parameters configured will apply to the UDP
configuration.
●
src_port - Specifies the UDP source port range.
- <value 0-65535> - Enter the UDP source port range value here.
●
mask - Specifies the UDP source port mask here.
- <hex 0x0-0xffff> - Enter the UDP source port mask value here.
●
dst_port - Specifies the UDP destination port range.
- <value 0-65535> - Enter the UDP destination port range value here.
●
mask - Specifies the UDP destination port mask here.
- <hex 0x0-0xffff> - Enter the UDP destination port mask value here.
●
protocod_id - (Optional) Specifies that the rule will apply to the value of IP protocol ID traffic.
●
<value 0-255> - Enter the protocol ID used here. This value must be between 0 and 255.
●
user_define - (Optional) Specifies that the rule will apply to the IP protocol ID and that the mask
options behind the IP header, which has a length of 20 bytes.
●
<hex 0x0-0xffffffff> - Enter the user-defined mask value here.
●
mask - Specifies the user-defined mask here.
- <hex 0x0-0xffffffff> - Enter the user-defined mask value here.
●
ipv6 - Specifies the rule applies to IPv6 fields.
●
class - (Optional) Specifies the value of IPv6 class.
●
<value 0-255> - Enter the IPv6 class value here. This value must be between 0 and 255.
●
source_ipv6 - (Optional) Specifies the value of IPv6 source address.