Extreme Networks EAS 200-24p Switch, Manual

Page: 625 / 908

config poe ports
Extreme Networks EAS 200-24p Switch CLI Manual
625
power. Whether the disconnect_method is set to deny_low_priority_port, priority of port will be
used by the system to manage to supply power to ports.
●
critical - Specifies that the priority will be set to critical.
●
high - Specifies that the priority will be set to high.
●
low - Specifies that the priority will be set to low.
●
power_limit - (Optional) Configure the per-port power limit. If a port exceeds its power limit, it will
be shut down.
●
class_0 - Specifies that the power limit will be set to class 0.
●
class_1 - Specifies that the power limit will be set to class 1.
●
class_2 - Specifies that the power limit will be set to class 2.
●
class_3 - Specifies that the power limit will be set to class 3.
●
user_define - (Optional) Specifies that a user defined per-port power limit will be used.
●
<value 1000-35000> - Enter the user defined per-port power limit here. This value must be
between m and n.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To config PoE port:
EAS 200-24p:admin#config poe ports 1-4 state enable priority critical power_limit
class_1
Command: config poe ports 1-4 state enable priority critical power_limit class_1
Power limit has been set to 4000 (Class 1 PD upper power limit 3.84W + power loss
on cable)
Success.
EAS 200-24p:admin#config poe ports 5 state enable priority critical power_limit
user_define 1000
Command: config poe ports 5 state enable priority critical power_limit user_define
1000
Power limit has been set to 1000 (User-define power limit should be greater than
1.18*PD_Request_Power, consider cable loss)
Success.
EAS 200-24p:admin#