Extreme Networks EAS 200-24p Switch, Manual

Page: 460 / 908

Chapter 29: Link Aggregation Command List
Extreme Networks EAS 200-24p Switch CLI Manual
460
config link_aggregation group_id
Description
Use to configure a previously created link aggregation group.
Format
config link_aggregation group_id <value 1-12> {master_port <port> | ports
<portlist> | state [enable | disable]}
Parameters
●
group_id - Specifies the group id. The group number identifies each of the groups.
●
<value 1-12> - Enter the group ID value here. This value must be between 1 and 12.
●
master_port - (Optional) Master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will share the
port configuration with the master port.
●
<port> - Enter the master port number here.
●
ports - (Optional) Specifies a range of ports that will belong to the link aggregation group.
●
<portlist> - Enter the list of port used for the configuration here.
●
state - (Optional) Allows you to enable or disable the specified link aggregation group. If not
specified, the group will keep the previous state, the default state is disabled. If configure LACP
group, the ports’ state machine will start.
●
enable - Enables the specified link aggregation group.
●
disable - Disables the specified link aggregation group.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To define a load-sharing group of ports, group-id 1, master port 17:
EAS 200-24p:admin# config link_aggregation group_id 1 master_port 17 ports 5-10,17
command: config link_aggregation group_id 1 master_port 17 ports 5-10,17
Success.
EAS 200-24p:admin#