Extreme Networks EAS 200-24p Switch, Manual

Page: 876 / 908

Chapter 68: Web-Based Access Control (WAC) Command List
Extreme Networks EAS 200-24p Switch CLI Manual
876
config wac ports
Description
Used to config state and other parameters of the ports.
Format
config wac ports [<portlist> | all] {state [enable | disable] | aging_time
[infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] | block_time
[<sec 0-300>]} (1)
Parameters
●
<portlist> - A port range to set their WAC state.
●
all - Configure all the switch ports’ WAC state.
●
state - (Optional) To specify the port state of WAC
●
enable - Specifies that the port state of WAC will be enabled.
●
disable - Specifies that the port state of WAC will be disabled.
●
aging_time - (Optional) A time period during which an authenticated host will keep in
authenticated state.
●
infinite - Indicates never to age out the authenticated host on the port
●
<min 1-1440> - Enter the aging time period here. This value must be between 1 and 1440
minutes.
●
idle_time - (Optional) If there is no traffic during idle time, the host will be moved back to
unauthenticated state
●
infinite - Indicates never to check the idle state of the authenticated host on the port.
●
<min 1-1440> - Enter the idle time period here. This value must be between 1 and 1440 minutes.
●
block_time - (Optional) If a host fails to pass the authentication, it will be blocked for a period
specified by “block_time”.
●
<sec 0-300> - Enter the blocking time here. This value must be between 0 and 300 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.