Extreme Networks EAS 200-24p Switch, Manual

Page: 280 / 908

Chapter 17: Connectivity Fault Management Command List
Extreme Networks EAS 200-24p Switch CLI Manual
280
●
ccm - (Optional) This is the CCM transmission state.
●
enable - Specifies that the CCM transmission will be enabled.
●
disable - Specifies that the CCM transmission will be disabled. This is the default value.
●
pdu_priority - (Optional) The 802.1p priority is set in the CCMs and the LTMs messages transmitted
by the MEP. The default value is 7.
●
<int 0-7> - Enter the PDU priority value here. This value must be between 0 and 7.
●
fault_alarm - (Optional) This is the control types of the fault alarms sent by the MEP.
●
all - All types of fault alarms will be sent.
●
mac_status - Only the fault alarms whose priority is equal to or higher than “Some Remote MEP
MAC Status Errors” are sent.
●
remote_ccm - Only the fault alarms whose priority is equal to or higher than “Some Remote
MEPs Down” are sent.
●
error_ccm - Only the fault alarms whose priority is equal to or higher than “Error CCM
Received” are sent.
●
xcon_ccm - Only the fault alarms whose priority is equal to or higher than “Cross-connect CCM
Received” are sent.
●
none - No fault alarm is sent. This is the default value.
●
alarm_time - (Optional) This is the time that a defect must exceed before the fault alarm can be sent.
The unit is centisecond, the range is 250-1000. The default value is 250.
●
<centisecond 250-1000> - Enter the alarm time value here. This value must be between 250 and
1000 centiseconds.
●
alarm_reset_time - (Optional) This is the dormant duration time before a defect is triggered before
the fault can be re-alarmed. The unit is centisecond, the range is 250-1000. The default value is 1000.
●
<centisecond 250-1000> - Enter the alarm reset time value here. This value must be between 250
and 1000 centiseconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a CFM MEP:
EAS 200-24p:admin# config cfm mep mepname mep1 state enable ccm enable
Command: config cfm mep mepname mep1 state enable ccm enable
Success.
EAS 200-24p:admin#