Extreme Networks EAS 200-24p Switch, Manual

Page: 164 / 908

Chapter 6: Access Control List (ACL) Command List
Extreme Networks EAS 200-24p Switch CLI Manual
164
●
enable - Specifies that the ACL counter option will be enabled.
●
disable - Specifies that the ACL counter option will be disabled.
●
replace_dscp - (Optional) Changes the DSCP of an un-conforming (yellow or red) packet.
●
<value 0-63> - Enter the replace DSCP value here. This value must be between 0 and 63.
●
exceed - Specifies the action when a packet is mapped to the “yellow” color.
●
permit - Permits the packet.
●
replace_dscp - Changes the DSCP of the packet.
- <value 0-63> - Enter the replace DSCP value here. This value must be between 0 and 63.
●
drop - Drops the packet.
●
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared when the
function is disabled.
●
enable - Specifies that the ACL counter option will be enabled.
●
disable - Specifies that the ACL counter option will be disabled.
●
violate - Specifies the action when a packet is mapped to the “red” color.
●
permit - Permits the packet.
●
replace_dscp - Changes the DSCP of the packet.
- <value 0-63> - Enter the replace DSCP value here. This value must be between 0 and 63.
●
drop - Drops the packet.
●
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared when the
function is disabled.
●
enable - Specifies that the ACL counter option will be enabled.
●
disable - Specifies that the ACL counter option will be disabled.
●
sr_tcm - Specifies “single rate three color mode”.
●
cir - Specifies the “Committed Information Rate”. The unit is Kbps.
●
<value 0-1048576> - Enter the committed information rate value here. This value must be
between 0 and 1048576.
●
cbs - Specifies the “Committed Burst Size” The unit is Kbytes.
●
<value 0-131072> - Enter the committed burst size value here. This value must be between 0 and
131072.
●
ebs - Specifies the “Excess Burst Size”. The unit is Kbytes.
●
<value 0-131072> - Enter the excess burst size value here. This value must be between 0 and
131072.
●
color_blind - (Optional) Specifies the meter mode as color-blind. The default is color-blind mode.
●
color_aware - (Optional) Specifies the meter mode as color-aware. The final color of the packet is
determined by the initial color of the packet and the metering result.
●
conform - (Optional) Specifies the action when a packet is mapped to the “green” color.
●
permit - Permits the packet.
●
replace_dscp - Changes the DSCP of the packet.
- <value 0-63> - Enter the replace DSCP value here. This value must be between 0 and 63.